SICK GM 32 In-Situ Process Gas Analyzer

Real-time gas analysis directly within the process

Innovative measurement technology that allows the devices to be mounted directly at the measurement site: In-situ gas analyzers take measurements directly within the process under system conditions. These analyzers are primarily characterized by their minimal maintenance requirements and extremely short response times. SICK’s in-situ gas analyzers are available in two different versions:

The cross-duct version for representative measurement results across the entire duct diameter
The measuring probe version, optimized for single-sided gas duct installation

At a glance

  • Direct, fast in-situ measurement
  • No gas sampling, no gas transport, no gas conditioning
  • Up to eight measuring components at the same time, plus process temperature and pressure
  • DOAS and CDE evaluation process
  • Numerous independent measuring ranges with consistent accuracy
  • Automatic self-test function (QAL3) without test gases
  • Overpressure encapsulated design for ATEX Zones 1 and 2
Your benefits
  • Measured values in real time without altering the gas composition
  • Short-term process deviations are detected
  • Representative measurement byselection of cross-duct or measuring probe versions
  • Fast on-site service due to modular design
  • Long maintenance-free intervals
  • Cost-effective in-situ gas analyzer — also in ATEX design
  • Low cost of installation and operation, no test gases required
  • Complete emissions measurement in Kraft pulp process by way of simultaneous measurement of TRS components plus SO2, NO, NH3