Real-time gas analysis directly within the process
Innovative measurement technology that allows the devices to be mounted directly at the measurement site: In-situ gas analyzers take measurements directly within the process under system conditions. These analyzers are primarily characterized by their minimal maintenance requirements and extremely short response times. SICK’s in-situ gas analyzers are available in two different versions:
The cross-duct version for representative measurement results across the entire duct diameter
The measuring probe version, optimized for single-sided gas duct installation
At a glance
- Direct, fast in-situ measurement
- No gas sampling, no gas transport, no gas conditioning
- Up to eight measuring components at the same time, plus process temperature and pressure
- DOAS and CDE evaluation process
- Numerous independent measuring ranges with consistent accuracy
- Automatic self-test function (QAL3) without test gases
- Overpressure encapsulated design for ATEX Zones 1 and 2
Your benefits
- Measured values in real time without altering the gas composition
- Short-term process deviations are detected
- Representative measurement byselection of cross-duct or measuring probe versions
- Fast on-site service due to modular design
- Long maintenance-free intervals
- Cost-effective in-situ gas analyzer — also in ATEX design
- Low cost of installation and operation, no test gases required
- Complete emissions measurement in Kraft pulp process by way of simultaneous measurement of TRS components plus SO2, NO, NH3
